Max pres

Kv

Orifice

Certification

Oil and fuel

For the most oils and fuels, a brass solenoid valve with FKM seals is a good choice. Solenoid valves can be direct or indirect operated. For indirect operated valves, a pressure difference is required across the inlet and outlet of typically... Read more Read more

Product Brand State Port Voltage Seal Housing Function Operation Min pres Max pres T/L Port Kv Orifice Max temp Power Connector Series Coil IP Torque Min temp Certification
Electrical Ball Valve BW2...
£60.79 (£73.56 incl vat)
In stock
JP Fluid Control - 3/4 inch 230V AC PTFE Brass 2 way Open-Close 0 10 - 21 15 110 5W - BW - IP54 4 -10 -
Electrical Ball Valve BW2...
£53.19 (£64.36 incl vat)
In stock
JP Fluid Control - 1/2 inch 230V AC PTFE Brass 2 way Open-Close 0 10 - 8.6 12 110 5W - BW - IP54 4 -10 -
Electrical Ball Valve BW2...
£75.99 (£91.95 incl vat)
In stock
JP Fluid Control - 1 inch 230V AC PTFE Brass 2 way Open-Close 0 10 - 26 20 110 5W - BW - IP54 4 -10 -
Solenoid Valve ST-SA 1/2''...
£35.14 (£42.52 incl vat)
In stock
JP Fluid Control Normally closed 1/2 inch 230V AC FKM Brass 2/2 way Semi-direct 0 16 - 1.49 10.5 120 17VA DIN - A ST CS1 IP65 - -10 -
Solenoid Valve ST-DA 1/4''...
£22.32 (£27.00 incl vat)
In stock
JP Fluid Control Normally closed 1/4 inch 12V DC FKM Brass 2/2 way Direct 0 13 - 0.2 3 120 13W DIN - A ST CS1 IP65 - -10 -
Electrical Ball Valve BW2...
£53.19 (£64.36 incl vat)
In stock
JP Fluid Control - 1/2 inch 24V DC PTFE Brass 2 way Open-Close 0 10 - 8.6 12 110 3W - BW - IP54 2.5 -10 -
Solenoid Valve ST-DA 1/4''...
£22.32 (£27.00 incl vat)
In stock
JP Fluid Control Normally closed 1/4 inch 24V DC FKM Brass 2/2 way Direct 0 13 - 0.2 3 120 13W DIN - A ST CS1 IP65 - -10 -
Electrical Ball Valve BW3...
£79.79 (£96.55 incl vat)
In stock
JP Fluid Control - 1 inch 230V AC PTFE Brass 3 way Open-Close 0 10 T-bore 16 18 110 5W - BW - IP54 4 -10 -
Solenoid Valve CM-DA 1/4''...
£20.42 (£24.70 incl vat)
In stock
JP Fluid Control Normally closed 1/4 inch 12V DC FKM Brass 2/2 way Direct 0 10 - 0.11 2 120 6W DIN - B CM CS4 IP65 - -10 -
Electrical Ball Valve BW2...
£53.19 (£64.36 incl vat)
In stock
JP Fluid Control - 1/2 inch 12V DC PTFE Brass 2 way Open-Close 0 10 - 8.6 12 110 3W - BW - IP54 2.5 -10 -
Solenoid Valve ST-DA 1/8''...
£21.37 (£25.85 incl vat)
In stock
JP Fluid Control Normally closed 1/8 inch 12V DC FKM Brass 2/2 way Direct 0 13 - 0.2 3 120 13W DIN - A ST CS1 IP65 - -10 -
Solenoid Valve CM-DA 1/4''...
£20.42 (£24.70 incl vat)
In stock
JP Fluid Control Normally closed 1/4 inch 230V AC FKM Brass 2/2 way Direct 0 13 - 0.11 2 120 8VA DIN - B CM CS4 IP65 - -10 -
Electrical Ball Valve BW2...
£60.79 (£73.56 incl vat)
In stock
JP Fluid Control - 3/4 inch 24V DC PTFE Brass 2 way Open-Close 0 10 - 21 15 110 3W - BW - IP54 2.5 -10 -
Electrical Ball Valve BW2...
£75.99 (£91.95 incl vat)
In stock
JP Fluid Control - 1 inch 24V DC PTFE Brass 2 way Open-Close 0 10 - 26 20 110 3W - BW - IP54 2.5 -10 -
Solenoid Valve ST-DA 1/4''...
£22.32 (£27.00 incl vat)
In stock
JP Fluid Control Normally closed 1/4 inch 230V AC FKM Brass 2/2 way Direct 0 13 - 0.2 3 120 17VA DIN - A ST CS1 IP65 - -10 -
Valves for Oils and Fuels - Tameson

Oil and fuel

For the most oils and fuels, a brass solenoid valve with FKM seals is a good choice. Solenoid valves can be direct or indirect operated. For indirect operated valves, a pressure difference is required across the inlet and outlet of typically 0.5 bar. In a closed circulating circuit, or a suction line, the differential pressure is usually too low. In this case, a (semi-)direct operated solenoid valve is recommended. Solenoid valves are suitable for clean liquids and gases. For contaminated media such as waste oil, other valve types such as (electric) ball valves, are more appropriate. Finally, solenoid valves are unsuitable for liquids with a high viscosity (higher than 50 Centistokes or mPa·s). Therefore, other valve types, such as electric ball valves, are better suited for viscous liquids such as heavy oils and fats.