Solenoid Valve HP-DA 1/4'' Brass FKM 0-100bar 120V AC
JP Fluid Control 2 way solenoid valve (type HP-DA) with G 1/4 inch threads and a 120 V AC coil. The circuit function of the solenoid valve is normally closed (voltage = open) and direct operating, so no pressure differential is required. Suitable for max media temperature of 120° C (248 ° F) pressure range of 0 - 100 bar (0 - 1450 psi). Housing of brass with FKM (FPM) sealing and a 1 mm orifice. The Kv-value is 0.03 m3/h (0.5 l/min at dp=1 bar water).
- Regular price
- £45.35
Description
This is a JP Fluid Control direct operating 2 way solenoid valve with G 1/4 inch threads and a 120 V AC coil. The valve has a brass housing with FKM (FPM) sealing and an orifice size of 1 mm (approximately 3/64 inch). The circuit function of the solenoid valve is normally closed, which means the valve opens when voltage is applied.
The valve is suitable for pressures of 0 - 100 bar (0 - 1450 psi) and a maximum temperature of 120° C (248° F). The valve has a Kv-value of 0.03 m3/h, which translates to a flow rate of 0.5 l/min at a differential pressure of 1 bar (for water). In imperial units: Cv = 0.03, which means 0.03 GPM @ 1 psi pressure drop. For simple applications it is often enough to select a valve based on the thread size and orifice diameter. For more accurate sizing, use the Kv-value with our easy to use valve sizing calculator.
The brass housing is durable, suitable for neutral fluids and resistant to many chemicals. Consult our chemical resistance chart to verify compatibility of housing and seals with the medium. The valve has an IP65 rating if properly connected.
Pros:
- Suitable for high pressures up to 100 bar
- Solenoid valves open and close very fast compared to many other valve types
- Delivered including coil and connector
- Good protection against the environment thanks to the IP65 rating
Cons:
- Solenoid valves are very sensitive to dirt and can only be used with clean liquids and gases
- Solenoid valves use energy while activated and the coil may get hot. A well ventilated installation environment is recommended to dissipate the heat
HP-DA series
The HP-DA is a directly operated, normally closed 2/2-way solenoid valve, specially designed for high pressure applications. The solenoid valves have an orifice of 3 mm, work from 0 bar and are suitable for very small flow rates. The body is available in brass and stainless steel with NBR, PTFE or FKM seal. The HP-DA solenoid valves are compatible with all the coils from the CS3 series.
The valves are available with BSP or NPT threads on request.
