FRL G1/2'' 3400 l/min 0.5-16.0bar/7-232psi (Externally Fitted Drain Valve) Polycarbonate Combo 2

This filter regulator lubricator (FRL) combines three functions. The filter removes water, dirt and other harmful particles larger than 40 microns. The pressure regulator adjusts the pressure continuously to a stable level, even when the input pressure varies. The level can be adjusted between 0.5 to 16.0 bar (7 to 232 psi). The lubricator introduces oil into the pneumatic air to reduce internal friction for pneumatic components. Most modern pneumatic equipment doesn't need lubrication, only use a lubricator if downstream equipment requires it. The recommended lubricating oil type is ISO-VG32 turbine oil. This model has G 1/2 inch ports. The maximum flow rate is 3400 l/min. Please note that the maximum flow rate alone doesn't provide enough information to proper sizing. Use the flow curve to determine if the pressure drop (droop) within your expected flow rate range is acceptable. The flow curve shows the flow rate for a set input pressure with multiple output pressures. For each output pressure, it can be seen how the pressure changes with increasing flow rate. It is recommended to use the device in the flat range of the curve, and not on the beginning or the end of the curve. Note that the pressure regulator controls the output pressure, not the flow rate. The output pressure can be adjusted by pulling the hand wheel up and twisting.

The maximum input pressure is 16.0 bar (232 psi) and the temperature range is between 0 and 50 °C (32 and 122 °F). It has an automatic (externally fitted drain valve) condensate drain with a drain capacity of 75 cm³. The lubricator requires a minimal flow rate of l/min and can hold 150 cm³ of oil. The housing material is made out of zinc die-cast and the filter and lubricator bowls are made of polycarbonate (PC).

Mounting brackets need to be ordered separately.